As an intelligent weak current system, cable bridge plays an important role in our daily life. But its usual problems will also give rise to confusion in our lives. Do you know what faults the cable bridge will present? Next, the small edition of Shandong cable bridge manufacturers will give you a summary!

，電纜的各部分都呈現短路表象，這類毛病可能會形成配電柜上的電流繼電器作業，對電纜形成的損壞十分嚴峻;

Firstly, all parts of the cable show the appearance of short circuit, which may lead to the operation of current relay on the distribution cabinet and cause serious damage to the cable.

第二，會呈現的毛?。弘娎|內部呈現短路，這類毛病通常是因?yàn)殡娎|質量低質而形成的，外表上不會流露痕跡;

Secondly, there will be defects: short-circuit inside the cable, which is usually caused by the low quality of the cable, and will not show traces on the surface;

第三，可能會呈現整條電纜被燒斷或許某處電纜被燒斷，使得電纜在毛病處損壞的十分嚴峻;

Thirdly, the whole cable may be burned or the cable may be burned somewhere, which makes the damage of the cable in the fault very serious.

第四，可能會呈現的毛病為電纜橋架只有一條短路，毛病處電纜損壞較輕，但還是會有很明顯的痕跡。

Fourthly, there may be only one short circuit in the cable bridge. The cable damage in the fault area is relatively light, but there are still obvious traces.

這類毛病可能會呈現的原因在于電流太大或許電纜質量太差而形成的。

This kind of fault may occur because the current is too large or the quality of the cable is too poor.

所有的機械設備使用后都要定期進行檢查、保養，電纜橋架廠家就來談?wù)勅绾螌?duì)電纜橋架設備進行檢修、保養。

All mechanical equipment should be inspected and maintained regularly after use. Cable bridge manufacturers will talk about how to repair and maintain cable bridge equipment.

1 、電纜橋架設備平衡氣缸動作狀況及其機油潤滑系統油路,接頭等測試檢查.

1. Test and check the balance cylinder action status of cable bridge equipment and oil circuit and joint of oil lubrication system.

2 、電纜橋架設備滑塊與導軌之間的摩擦較為頻繁，應做必要的調整較正，檢查接頭部位的潤滑及管路等，保證良好的運轉。

2. Friction between slider and guide rail of cable bridge equipment is frequent. Necessary adjustment and correction should be made to check the lubrication quality and pipeline of joints to ensure good operation.

3 、定期為電纜橋架設備齒輪部位潤滑：齒輪傳動箱及內部機件因?yàn)榻?jīng)常運轉損壞的可能性比較大，出現松動的可能性更大。

3. Lubricate the gear parts of cable bridge equipment regularly: the gear transmission box and internal parts are more likely to loosen because of frequent operation damage.

本文由山東電纜橋架的小編進行整理編寫，想要了解更多的產品及更詳細的精彩內容，請關注我們的網站：http://66343.cn，我們十分感謝您的支持！

This article is compiled by the small edition of Shandong Cable Bridge Frame. For more products and more detailed wonderful content, please pay attention to our official website: http://66343.cn. We thank you very much for your support!